Pre-printed and currently in stock - you don't have to wait weeks to get this
awesome smiling ghost bath bomb mold!
This mold is easier on your hands, and easier to use than a three piece mold!
This style of mold does not require a top and bottom piece. It produces a
bath bomb with a beautiful decoration on one side, while the other side is
NOT for use in bath bomb presses - bath bombs are made by filling the mold,
compressing it by hand, and trimming off the excess bath bomb mix.
Printed with PLA plastic so please wash in cold water only, and do not soak as
they can retain water.
Dimensions of finished bath bomb: approximately 3.75 x 2 x 1 inches. The
weight of your finished bath bomb will vary based on your bath bomb recipe and
how firmly you pack the mold.
These molds are a single piece of 3D printed plastic and do not contain a bath
bomb ring, or separate top and bottom pieces.
Colors vary based upon our filament supply and our choosing, though we
generally use black.
Bath bombs are not included.
To use, add a small amount of your bath bomb mix to the bottom, and press it
into the design, especially the edges on the bottom. Continue to fill while
compacting the mix with your fingers, until it is overfilled. Compress the mix
further using your palm.
Trim the excess compressed mix using a spatula or other flat but rigid
instrument, then hit the edge of the mold with the mix side down against a
surface. If the bomb does not slide out easily, gently tap the sides to break
the vacuum and it should slide right out.